-
8 Zone Asenware Fire Alarm Control Panel
8 Zone Asenware Fire alarm control panel Specification:-
It is modularized design, the panel can expend from 1 zone to 32 zones easily.
It has 2 level control mode by a lock
It has 24VDC and 5VDC power supply output.
It has FIRE and FAULT signal output.
It has 2 general sounders output.
Each zone has 1 circuit detectors input .
Each zone can be disable by a button.
It has RESET button to reset the panel.
It has SILENCE button to stop BUZZER and SOUNDERS.
It has EVACUATE button to start a manual fire alarm immediately.
It has battery low protection function, when battery voltage lower than 21VDC, battery will be cut off automatically until the mains power is on.
It has an optional GSM module for fire alarm by SMS .KSh22,000.00KSh25,000.008 Zone Asenware Fire Alarm Control Panel
KSh22,000.00KSh25,000.00 -
Asenware Battery Powered Stand Alone Smoke Detector
Asenware Battery Powered Stand Alone Smoke Detector is a photo-detector that uses the most advanced optical sensing chamber. It is designed to provide open area protection without wiring, and it is easy to install and construct.
Asenware Battery Powered Smoke Detector specifications:-
Operating Voltage:- 9VDC(with battery)
Operating Current:- Monitoring Status <= 8uA, alarm status<= 20mA Temprature:- -10 Degree Celcius ~ 55 Degree celcius Relative humidity:- <= 95% non condensing Protection class: IP20 Application: Indoor use only Smoke Alarm Sensitivity:- 0.18 to 0.26 dBM Alarm level: >= 85dB@3m and >= 93dB@1m
Materials and colors:- ABS, whiteKSh1,400.00 -
Asenware Fire Alarm Smoke Detector
Asenware Fire Alarm Smoke Detector uses a state-of-the-art optical sensing chamber. This detector is designed to provide open area protection and to be used with the most conventional fire alarm panel.
- Operating Voltage Range: 9 to 28 VDC Non-polarized
- Standby Current: ≤120uA@24VDC
- Maximum Alarm Current(LED on): ≤15mA@24VDC（1K Ohm current-limiting resistance）
- Operating Humidity Range: ≤95%RH(40℃±2℃)RelativeHumidity, Non-condensing
- Operating Temperature Range: -10℃ to 50℃(14ºF to 122ºF)
- Smoke Alarm Sensitivity: 0.1-0.15dB/m
- Height: 48.2mm installed in Base
KSh1,200.00Asenware Fire Alarm Smoke Detector
KSh1,200.00 -
Conventional Manual Call Point AW-D135C
The AW-D135C Conventional manual call point is designed to be use with an intelligent two-wire control system. If it is pressed after a fire is manually confirmed, an alarm signal may be sent to a fire alarm control system which will, after receiving the alarm signal, display the equipment status of the manual fire call points. When the manual fire call points is operating normally, the red indicator will blink; when there is a fire alarm, it will remain lit.
This passage will introduce the features, installation, wiring and use of AW-D135C conventional manual call point, to help you understand more about the conventional manual call point.
KSh999.00Conventional Manual Call Point AW-D135C
KSh999.00 -
Druid 13LCD Energizer
Druid 13LCD Energizer
- 3 Joule output energy (single zone)
- Robust and flexible design for home security
- Built-in alarm monitors tampering or faults on the high voltage and earth fence wires
- Connectable to armed response radio or GSM module
- Lightning and power surge protection
- Intelligent power saving to extend battery life
- Easy-to-use tag included for controlling the energizer
- Walk test mode for easy fence testing
- The LCD background colour changes to easily identify the fence condition
- Powered by 240V mains and includes built-in battery for back-up power
- Built-in gate alarm input to monitor if the gate is open or closed
- Optional keypad for controlling and programming the energizer. This allows the user to control the energizer remotely, with up to two keypads
KSh22,500.00KSh23,000.00Druid 13LCD Energizer
KSh22,500.00KSh23,000.00 -
Fire Alarm Sounder and Strobe Light
Fire Alarm Sounder and Strobe Light is powered by a 24v electrical circuit. In the event of a fire, the sounder will sound and flash at the same time. Very stable and reliable; easy to install and wire; can be used in different emergency situations.
- Adopt the two-wire or the four-wire system wiring method
- The mainline end receives two main lines, No polarization
- Connect the power end to a DC24V power line.
KSh1,700.00Fire Alarm Sounder and Strobe Light
KSh1,700.00 -
Portable Horus E1 With Inbuilt Backup Battery Time Attendance Terminal
· A new height of facial recognition template capacity – up to 6000 facial templates for 1:N recognition.
· Anti-spoofing algorithm against print attack (laser, color, and B/W photos), videos attack, and 3D mask attack.
· Multiple communication protocols are available: 4G, Wi-Fi, Bluetooth, and USB.
· 5-inch smartphone grade IPS touch LCD.
· 2MP CMOS with WDR.
· Various further development options: embedded GPS / A-GPS, microphone and PIR sensor.
· Positioning attendance records only support sending to platform of BiotimeKSh45,000.00 -
Smart D5 EVO Centurion Sliding Gate Motor
D5 EVO – Smart Centurion Sliding Gate Motor Technical Specifications :-
Input voltage (1) 110V – 240V AC 50/60Hz (1)
Current consumption (mains) 320mA peak
Dx12V Battery charger current output 1.8A @ 14.3V +/- 5% (28W)
Maximum number of operations per day 150 (3,6)
Duty cycle – Mains present (2,3) 50%
Motor power supply Battery-driven (Standard Capacity – 1x12V)
Current consumption (motor at rated load) 15A
Input / Output sink currents (Max. accessory current draw)
I/O 4 and I/O 5 100mA (12V)
O6 3A (12V) 10sec PulseKSh60,000.00Smart D5 EVO Centurion Sliding Gate Motor
KSh60,000.00 -
SpeedFace-V5L Series
- Face / Fingerprint / Palm
(Customized) / Card / Password
(Virtual Keypad)
Fingerprint Capacity - 6,000 (1:N) (Standard) / 10,000 (1:N) (Optional) / 6,000 (1:1)
Face Capacity - 6,000 (1:N) (Standard) / 10,000 (1:N) (Optional) / 6,000 (1:1)
Palm Template Capacity (Customized) - 3,000 (1:N) (Standard) / 3,000 (1:1)
Card Capacity - 10,000 (1:N) (Optional) / 10,000 (1:1)
Transaction Capacity - 200,000 (1:N) (Optional for Capacity Expansion)
KSh37,000.00SpeedFace-V5L Series
KSh37,000.00 - Face / Fingerprint / Palm
-
ZKTeco C3-400 4 Door IP Based Controller
IP-based Door Access Control Panel for four doors with built-in access control functions and Wiegand readers support. Communication TCP/IP and RS-485. Capacity 30000 cards, 100000 transactions. Support 4 readers.
KSh27,000.00ZKTeco C3-400 4 Door IP Based Controller
KSh27,000.00 -
ZKTeco F18 Biometric Fingerprint access control
The Zkteco zk F18 is an Innovative Reader used for both access control and time attendance applications. The device has three levels of security i.e Fingerprint Reader, RFID Reader, and PIN access. Zkteco F18 can be installed as a standalone device or with a third-party controller using the Wiegand protocol.
KSh14,500.00ZKTeco F18 Biometric Fingerprint access control
KSh14,500.00 -
ZKTeco F22 WI-FI time attendance and access control
F22 is an ultra-thin fingerprint time attendance and access control terminal with Wi-Fi, which offers unparalleled performance with advanced algorithm for reliability, precision and excellent matching speed. F22 features the fastest commercial-based fingerprint matching algorithm and ZKTeco high-performance, high-image quality infrared detection fingerprint sensor.
KSh13,500.00KSh16,000.00ZKTeco F22 WI-FI time attendance and access control
KSh13,500.00KSh16,000.00
